GAF
Timberline HDZ
Colors, package levels, and material details are added when you build your estimate.
Staten Island Roofing
Roofing in Staten Island, NY
Roof replacement, roof repair, and roofing-system guidance for Staten Island homes. Start with your property and get a clearer understanding of what your roof may require before scheduling an on-site verification.
What we do
Roofing Services for Staten Island Homes
- 01
Roof Replacement
Complete tear-off and installation of a new roofing system, including evaluation of the exposed roof deck and required protective layers.
- 02
Roof Repair
Diagnosis and repair of leaks, damaged roofing, flashing problems, penetrations, and localized failures.
- 03
Flat & Low-Slope Roofing
Roofing-system options for flat and low-slope sections common on residential and mixed-use buildings.
- 04
Emergency Roofing
Urgent temporary protection and evaluation when active leaks or storm-related damage require prompt attention.
Property-specific estimating
Start With the Roof You Actually Have
Instead of a generic square-foot number, our online roof estimator begins with your address and uses available property and aerial roof information to describe the roof on your home.
Aerial information can be incomplete, out of date, or require manual verification — additions, dormers, tree cover and low-slope sections are common reasons a measurement needs review. Final pricing is always verified against actual site conditions during an on-site inspection.
- 01
Roof surface area
An approximate measurement of the roof surfaces detected on the property.
- 02
Roof pitch
The primary slope of the roof, which affects materials, labor and access.
- 03
Roof geometry
Segment counts, valleys and transitions that shape how a roof is built.
- 04
System requirements
The likely underlayment, waterproofing, flashing and ventilation a roof calls for.
- 05
Preliminary scope
An early view of what the project may involve before anyone climbs a ladder.
On the roof
What We Look for on Staten Island Roofs
Staten Island homes vary widely in age, roof design and materials. The conditions below are examples of what may affect the scope of a roofing project — not a list of problems every property has.
Aging asphalt shingles
Granule loss, curling, cracking or brittleness can indicate a roof approaching the end of its service life.
Chimney and penetration flashing
Chimneys, vents, skylights and pipe boots rely on flashing details that often fail before the roofing field does.
Valleys and transitions
Valleys and roof-to-wall transitions concentrate water, so their condition can drive the scope of a project.
Low-slope sections
Porches, dormers and rear extensions frequently include flat areas that need a different roofing system than the main roof.
Soft or deteriorated decking
Decking that has absorbed moisture may need replacement once the existing roofing is removed and the deck is visible.
Previous roof layers
More than one layer of existing roofing affects tear-off labor, disposal and what the deck underneath can be evaluated for.
Drainage and water intrusion
Gutters, drainage paths and interior staining help trace where water is entering rather than where it appears.
Storm or wind damage
Lifted, missing or displaced roofing after a storm may be localized, or may point to a broader condition.
The process
From Roof Analysis to Finished Roof
The same sequence used on the interactive roof-system visualization on our homepage, applied to a Staten Island project.
- 01
Property analysis
Your address is used to pull available property and aerial roof information.
- 02
Roof verification
The detected building and measurements are reviewed and confirmed with you.
- 03
Roofing-system selection
Material and system options are matched to the roof and the project.
- 04
Existing roof removal
Where required, the existing roofing is removed so the deck can be seen.
- 05
Deck inspection and repair
Exposed decking is inspected and repaired or replaced where needed.
- 06
Waterproofing and underlayment
Protective layers are installed at vulnerable areas and across the deck.
- 07
Installation and final inspection
The finished roofing system is installed and the completed work is reviewed.
Roofing systems
Roofing Systems and Materials
Most Staten Island homes use an asphalt shingle system. Explore the shingle lines below, or compare them in more detail on the homepage materials section.
CertainTeed
Landmark
Colors, package levels, and material details are added when you build your estimate.
Owens Corning
Duration
Colors, package levels, and material details are added when you build your estimate.
Flat and low-slope areas are handled differently. Depending on the property, those sections may call for a system such as modified bitumen, TPO, or EPDM rather than shingles.
Service area
Serving Staten Island
We work across the borough, from the South Shore neighborhoods of Tottenville, Annadale, Huguenot, Eltingville and Great Kills to New Dorp, Dongan Hills and the hillside homes around Todt Hill.
And communities throughout Staten Island.
- Great Kills
- Tottenville
- Eltingville
- New Dorp
- Todt Hill
- Dongan Hills
- Annadale
- Huguenot
Common Questions
Staten Island Roofing Questions
Answers to what homeowners most often ask before starting a roof replacement or repair.
Get started
Start With Your Staten Island Property
Enter your address to begin a preliminary roof analysis and learn more about what your roofing project may require.